Partios Wholesale catalogue

Monroe Distributor | Suspension & Steering

Suspension shock absorber (2,747) · Coil spring (2,341) · Wheel suspension track control arm, front (1,352) · Gas spring (1,135) · Stabilizer link (786) · Tie rod end (693) · Macpherson strut mount (404) · Tie rod (with no end) (390) · 42 further part types (2,269)

12,796 current catalogue lines

About the MONROE range

Monroe is a suspension & steering brand, and the range Partios carries reaches across 50 part types. The largest groups are suspension shock absorber (2,747), coil spring (2,341), wheel suspension track control arm, front (1,352), gas spring (1,135) and stabilizer link (786). Beyond those, 3,063 lines are spread across 44 further part types. That tail includes macPherson strut mount, tie rod (with no end) and front ball joint. Buyers are typically workshops, suspension specialists, motor factors and exporters; suspension and steering parts are commonly replaced in pairs, so matched availability across an axle is the practical constraint. With 12,796 lines on the catalogue, most common applications in this area are covered without needing a second source.

Catalogue products

Vehicle references are indicative — confirm against the article number.

MONROE Front ball joint L50040

Axle ball joint L/R (bottom/outer front) (cone diameter 18mm) fits: VOLVO XC60 I FORD MAVERICK FORD USA PROBE II KIA CLARUS MAZDA 3, 323 F VI, 323 S VI, 5, 626 II, 626 III, 626 IV 1.3-3.0 11.82-

View part

MONROE Tie rod end L50105

Tie rod end L/R fits: MAZDA 121 II, 323 C IV, 323 C V, 323 F IV, 323 F V, 323 P V, 323 S IV, 323 S V, DEMIO, MX-3, RX-7 III 1.1-2.0D 04.87-07.03

View part

MONROE Tie rod end L50107

Tie rod end L/R fits: FORD USA PROBE I, PROBE II MAZDA 323 F VI, 323 S VI, 626 III, 626 IV, 626 V, MPV II, MX-6, PREMACY, XEDOS 6 1.3-3.0 06.87-12.06

View part

MONROE Tie rod end L50155

Tie rod end R fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Tie rod end L50156

Tie rod end L fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Tie rod end L50159

Tie rod end R fits: MAZDA 2 1.3-1.6D 07.07-06.15

View part

MONROE Tie rod end L50160

Tie rod end L fits: MAZDA 2 1.3-1.6D 07.07-06.15

View part

MONROE Tie rod end L50161

Tie rod end R fits: MAZDA CX-7, CX-9 2.2D-3.7 06.06-

View part

MONROE Tie rod end L50162

Tie rod end L fits: MAZDA CX-7, CX-9 2.2D-3.7 06.06-

View part

MONROE Tie rod end L50163

Tie rod end R fits: MAZDA 6 1.8-2.5 08.07-07.13

View part

MONROE Tie rod end L50164

Tie rod end L fits: MAZDA 6 1.8-2.5 08.07-07.13

View part

MONROE Tie rod end L50165

Tie rod end L/R fits: MAZDA CX-5 2.0/2.2D/2.5 11.11-02.17

View part

MONROE Tie rod end L50167

Tie rod end R fits: MAZDA 3, 6 1.5-2.5 08.12-

View part

MONROE Tie rod end L50168

Tie rod end L fits: MAZDA 3, 6 1.5-2.5 08.12-

View part

MONROE Tie rod (with no end) L50211

Tie rod (with no end) L/R (length: 308mm) fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Tie rod (with no end) L50212

Tie rod (with no end) L/R (length: 199,5mm) fits: MAZDA 6 1.8-2.3 01.02-02.08

View part

MONROE Tie rod (with no end) L50219

Tie rod (with no end) L/R (length: 324,5mm) fits: MAZDA 626 V, XEDOS 6 1.6-2.0D 01.92-10.02

View part

MONROE Tie rod (with no end) L50226

Tie rod (with no end) L/R (length: 230mm) fits: FORD FIESTA VI MAZDA 2 MITSUBISHI LANCER VIII 1.25-1.6D 07.07-

View part

MONROE Tie rod (with no end) L50227

Tie rod (with no end) L/R (length: 182,5mm) fits: MAZDA 6 1.8-2.5 08.07-07.13

View part

MONROE Tie rod (with no end) L50228

Tie rod (with no end) L/R (length: 303,5mm) fits: MAZDA CX-5 2.0/2.2D/2.5 11.11-02.17

View part

MONROE Tie rod (with no end) L50229

Tie rod (with no end) L/R (length: 236mm) fits: MAZDA 3, 6 1.5-2.5 08.12-

View part

MONROE Front ball joint L50505

Axle ball joint L/R (top front) (cone diameter 15mm) fits: FORD RANGER MAZDA B-SERIE 1.8-4.0 12.89-11.06

View part

MONROE Front ball joint L50506

Axle ball joint L/R (bottom front) (cone diameter 20,1mm) fits: FORD RANGER MAZDA B-SERIE 1.8-3.0 01.85-06.06

View part

MONROE Front ball joint L50507

Axle ball joint L/R (bottom front) (cone diameter 20mm) fits: FORD RANGER MAZDA B-SERIE 2.2-4.0 02.99-11.06

View part

MONROE Front ball joint L50508

Axle ball joint L/R (bottom front) (cone diameter 16mm) fits: MAZDA 323 C IV, 323 C V, 323 F IV, 323 F V, 323 P V, 323 S IV, 323 S V, MX-3 1.3-2.0D 04.87-12.98

View part

MONROE Front ball joint L50515

Axle ball joint L/R (bottom/outer front) (cone diameter 18mm) fits: MAZDA 323 C IV, 323 C V, 323 F IV, 323 F V, 323 P V, 323 S IV, 323 S V, MX-3 1.3-2.0D 06.89-09.98

View part

MONROE Wheel suspension track control arm, front L50521

Front axle track control arm R bottom/transverse front 18 mm fits: MAZDA 323 F VI, 323 S VI, PREMACY 1.3-2.0D 05.98-03.05

View part

MONROE Wheel suspension track control arm, front L50523

Front axle track control arm R bottom front fits: MAZDA 6 1.8-2.3 01.02-02.08

View part

MONROE Wheel suspension track control arm, front L50524

Front axle track control arm L bottom front fits: MAZDA 6 1.8-2.3 01.02-02.08

View part

MONROE Wheel suspension track control arm, front L50525

Front axle track control arm L/R bottom front fits: MAZDA 6 1.8-2.3 01.02-02.08

View part

MONROE Wheel suspension track control arm, rear L50526

Rear axle track control arm L/R (top, rear, transverse) fits: MAZDA 6 1.8-2.5 08.07-

View part

MONROE Wheel suspension track control arm, front L50531

Front axle track control arm R bottom front fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Wheel suspension track control arm, front L50532

Front axle track control arm L bottom front fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Wheel suspension track control arm, rear L50535

Rear axle track control arm L/R (outer/top, rear, transverse, with rubber pad) fits: MAZDA 6 1.8-2.3 01.02-02.08

View part

MONROE Front ball joint L50541

Axle ball joint L/R (bottom front) (cone diameter 18mm) fits: MAZDA MX-5 I, MX-5 II 1.6/1.8 05.90-10.05

View part

MONROE Front ball joint L50542

Axle ball joint (front) (cone diameter 22mm) fits: FORD USA EDGE MAZDA CX-7, CX-9 2.0-3.7 06.06-

View part

MONROE Front ball joint L50546

Axle ball joint L/R (bottom/outer front) (cone diameter 20mm) fits: MAZDA 3, 6, CX-3, CX-30, CX-5 1.5-2.5H 11.11-

View part

MONROE Wheel suspension track control arm, front L50549

Front axle track control arm R top front fits: MAZDA 6 1.8-2.5 08.07-07.13

View part

MONROE Wheel suspension track control arm, front L50550

Front axle track control arm L top front fits: MAZDA 6 1.8-2.5 08.07-07.13

View part

MONROE Front ball joint L50551

Axle ball joint (front) (cone diameter 18mm) fits: MAZDA 3, 5 1.3-2.3 10.03-

View part

MONROE Front ball joint L50552

Axle ball joint (top front) (cone diameter 12,6mm) fits: MAZDA 6 1.8-2.5 01.02-07.13

View part

MONROE Wheel suspension track control arm, front L50553

Front axle track control arm R bottom/transverse front (with a joint (knuckle) with rubber pad) fits: MAZDA 3 1.6-2.3 12.08-09.14

View part

MONROE Wheel suspension track control arm, front L50554

Front axle track control arm L bottom/transverse front (with a joint (knuckle) with rubber pad) fits: MAZDA 3 1.6-2.3 12.08-09.14

View part

MONROE Wheel suspension track control arm, front L50557

Front axle track control arm R bottom/transverse front (with a joint (knuckle) with rubber pad) fits: MAZDA 6, CX-5 2.0/2.2D/2.5 11.11-

View part

MONROE Wheel suspension track control arm, front L50558

Front axle track control arm L bottom/transverse front (with a joint (knuckle) with rubber pad) fits: MAZDA 6, CX-5 2.0/2.2D/2.5 11.11-

View part

MONROE Stabilizer link L50602

Stabilizer link front/rear L/R , quantity per axle: 2 fits: DAIHATSU CHARMANT HYUNDAI ACCENT, ACCENT I KIA SEPHIA, SHUMA MAZDA 323 C IV, 323 F IV, 323 III, 323 S IV, 626 II 1.1-2.4 01.78-10.01

View part

MONROE Stabilizer link L50603

Stabilizer link front R 105mm fits: FORD USA PROBE I, PROBE II KIA CLARUS MAZDA 323 C V, 323 F V, 323 P V, 323 S V, 626 III, 626 IV, 626 V, CX-7, MX-5 II, MX-5 III, MX-6 1.3-3.0 09.87-12.14

View part

MONROE Stabilizer link L50604

Stabilizer link front L 105mm fits: FORD USA PROBE I, PROBE II KIA CLARUS MAZDA 323 C V, 323 F V, 323 P V, 323 S V, 626 III, 626 IV, 626 V, CX-7, MX-5 II, MX-5 III, RX-8 1.3-3.0 09.87-12.14

View part

Buying with Partios

Buying MONROE parts through Partios

Are these genuine MONROE parts?

Yes. Every MONROE line here is sourced through Partios's ISO 9001:2015-certified European distribution network.

Can you source MONROE parts that aren't showing in stock?

Yes. Partios runs a prepayment-only, manufacturer-order model, so we can place a manufacturer order for MONROE lines that aren't currently available.

Do you supply MONROE parts for export?

Yes. We serve motor factors, exporters and resellers. Export orders are handled the same way as UK trade orders.

How do I get trade pricing on MONROE parts?

Apply for a Partios Wholesale trade account to see trade pricing and availability.

What lead time should I expect on a MONROE order?

It depends on the line. Stocked MONROE items are dispatched within 24 hours of payment for parcel orders, or up to 48 hours for pallet orders depending on size. For lines placed as a manufacturer order, we confirm the lead time with the manufacturer before the order goes in, so you know the timescale before you pay.

Is there a minimum order quantity for MONROE parts?

No. There's no minimum order value or quantity on a Partios trade account. Some MONROE lines are supplied in manufacturer pack sizes, which are shown on the product listing.

No registration needed

See what we can source

Upload your parts list and we’ll match it against the full catalogue. Add up to 50 rows, with no account needed.

Try the Parts Finder

Ready to see trade pricing and availability? Apply for a Partios Wholesale account.

Apply for a trade account